Dear all,
I am launching a simulation of a pipe whch by expansion hits a wall. the wall is placed at 9m of the pipe in the Y-direction.
to simulate the contact, I created a new entity (the wall) and i gives to my wall propriety of a contact.
*CONTACT PAIR,INTERACTION=WALL
PIPESURF_WALL,WALL...
is it enough to juste include *WRITE as this
*INCLUDE,INPUT=operating_cycle_Temp8.inp
*WRITE
*INCLUDE,INPUT=operating_cycle_Temp9.inp
*WRITE
*INCLUDE,INPUT=operating_cycle_Temp10.inp
*WRITE
*INCLUDE,INPUT=operating_cycle_Temp11.inp
*WRITE
*INCLUDE,INPUT=operating_cycle_Temp12.inp
Dear all,
I am launching a fatigue analysis with several operating and shut down cycles. and I wish sawve output files after some steps.the aim is to restart from this outputfiles a transient analysis.
if you need more information, I'm available
thanks in advance
Dear all,
I am starting on abaqus and this question can seem obvious but I was wondering if It's possible to start a calculation from previous results on ABAQUS. By the way, I am trying to simulate the deformation of a pipe under several pressure and temperature profiles, as I am not sure of...
