Hello.
I have a case, that probably is easy to explain, but that I'm stuck on for the moment.
In picture below there are 3 plates connected to each other by guide pins.
The left and right side of the 2 outer plates are fixed.
Blue and red areas are cavities where a pressure is applied.
In this...
Hi.
Perhaps a stupid question, but here I go....
How do I input stress/strain data from a tensile test into an elasto-plastic material model in FEA?
The program states that the starting point should be the yield point.
Attached You'll find the results and graphs from 2 tests bars.
Result on...
