I have a 25000 pound (15V max) load cell that is supplied by a battery pack/converter which puts out 12.22 VDC. The load cell is read via DAQ board by laptop. The issue I am having is that the noise level (without any load) is approximately 1mV which according to what I have calibrated with...
I have a 25000 lb rated load cell that I need to supply with 12Vdc, I have a battery pack that puts out approximately 37Vdc. The resistance in the load cell is 350 Ohms. My concern is that if I step down the battery pack with a converter from the 37Vdc to 12Vdc, what kind of current am I going...
I have a load cell rated for 25000 lbs and such requires an excitation voltage of 10V. The DAQ board that came with it can only supply 5V and all this testing will be done in a remote location meaning I'll only have a truck as a power supply and any batteries I may need. How can I meet the 10V...
So I have an air cylinder similar to the picture posted and what I need is a some sort of device that will connect the bottom rod to the base of the cylinder and then quick release it after it has been pressurized. I need to be able to adjust the height of the rod so I was thinking of some sort...
I am working on an impact hammer to test for anomalies in soil, essentially locating sinkholes. I have a 3 foot air cylinder that I need to hang from a steel frame. Ideally I would like it to be able to hang plum with the ground regardless of the slope in which the frame is sitting on. How can I...
