Hello,
I am looking for technical information on the design of pressure-stabilized tank or "balloon tank". That kind of tank was used for the propellants of the centaur upper stage rocket. I have found a few documents online but I was wondering of some people might have experience with that...
Hello,
I am looking for technical information on the design of pressure-stabilized tank or "balloon tank". That kind of tank was used for the propellants of the centaur upper stage rocket. I have found a few documents online but I was wondering of some people might have experience with that...
Hello,
I'm working with some ceramic tubes of small diameter (~0.08"OD) that I need to implement in a heat exchanger. I'm looking for documentation or design advise on how I could connect/seal them to a tubesheet as I don't have lot of experience in this. Pressure expected are around 200psi...
Hello,
I have some flexible tubes of PFA (1/8" OD 1/16"ID) that I need to bond to a larger PFA tube (rigid). I was wondering what was the best way to do that. I just ordered some epoxy for PFA and I was also looking into plastic welding. What would be your advise on the best way to do that? The...
Hello,
I have some flexible tubes of PFA (1/8" OD 1/16"ID) that I need to bond to a larger PFA tube (rigid). I was wondering what was the best way to do that. I just ordered some epoxy for PFA and I was also looking into plastic welding. What would be your advise on the best way to do that? The...
Hello,
I'm looking for a manifold made of PTFE/PFA to connect PTFE/PFA tubing. The best for me would be to have the tube "plastic welded" to that manifold but I am not really familiar with this technology. The assembly would be pressurized at 6bar at ambient temperature. The tubing have a 1/8"...
Hello,
I'm looking for a manifold made of PTFE/PFA to connect PTFE/PFA tubing. The best for me would be to have the tube "plastic welded" to that manifold but I am not really familiar with this technology. The assembly would be pressurized at 6bar at ambient temperature. The tubing have a 1/8"...
Hello,
I need to connect ceramic (aluminium oxide) tubes to a flexible tube (right now I have PTFE and PFA, but I'm open to other suggestions). The method I use currently is to fit the ceramic tubes in the flexible tube (the ID of the flexible tube is slightly smaller than the OD of the ceramic...
Hello,
I need to connect ceramic (aluminium oxide) tubes to a flexible tube (right now I have PTFE and PFA, but I'm open to other suggestions). The method I use currently is to fit the ceramic tubes in the flexible tube (the ID of the flexible tube is slightly smaller than the OD of the ceramic...
Hello,
I'm working on a project where I need to connect 20-60 small diameter tubes (ID 1/16", OD 1/8") made of PTFE (or similar). I run compressed air through it at a pressure of 3-10 bar.
I'm trying to find a company that would sell or manufacture a manifold for my application (manifold with...
Hello,
I'm working on a project where I need to connect 20-60 small diameter tubes (ID 1/16", OD 1/8") made of PTFE (or similar). I run compressed air through it at a pressure of 3-10 bar.
I'm trying to find a company that would sell or manufacture a manifold for my application (manifold with...
Hello,
I'm working on a safety report for an experiment I'll be working for. It involve pressure vessel and pipes under pressure that will be heated. For the safety clearance, I need to demonstrate the effect of a "worst case scenario", that would be
1) Overpressure of the pressure vessel...
