While our Design Department is using NX we are looking for a viewer that has measuring capabilities for parasolids and step files for the rest of the company. Does anyone use a viewer for their non-design departments?
I created a workflow that assigns a reviewer to check before assigning a status to an item revision. Upon reject there is a do task for the designer to make changes and send back to the reviewer.
Is there a way I can keep the process in the reviewers "Tasks to Track" worklist when after...
I have a laptop that runs NX 7.5 at an acceptable level. Should I expect this same hardware to run NX 9/10 as well or are the requirements becoming more demanding as new versions are released.
We are looking at upgrading a few components (like an SSD) in the laptop now and are questioning if it...
On a regular basis we receive step files with geometry that is intended to be solid but instead are separate surfaces with edges that do not align well. These surfaces will not sew into a solid because of it. Is there a good way to fix this problem or perhaps another software that can fix issues...
There is a lot of talk of older and newer commands. Is there a list somewhere of what commands are better to use then others for example section curves or intersection curves?
NX 7.5.5.4
TC 8.3.2
Is there a way to display a 360 degree view on a drafting sheet, for example showing the entire tread pattern of a tire in a long rectangular view.
NX 7.5.5.4
TC 8.3.2
I am in the process of designing a new title block. Currently a pattern is brought in for the block geometry and the field are all populated by notes where some reference expressions.
Instead of trying to make my old ways work, what other options are there if I were want to start fresh with a...
I am looking to run checkmate on only the deliverable portion of my NX part. Is there a way to limit checkmate to a specific layer or reference set. Perhaps only what is not blanked?
