Hi,
I am trying to study the difference between the static structural results of a 3D model and Beam model. I used a simple I beam example whereby one end of the beam is fixed support and the other end is a load downwards 100kN. When I compared the max von mises stress between both models, the...
Hi all,
I hope someone could point me to the right direction for my queries below. I am not a structural engineer myself:
I understand that shear force exerted on a web could induce buckling load on it and also induce compressive load on the stiffener. I also understand that there are...
Hello.
I am doing an analysis of an electronic chip undergoing thermal cycles. I am using a slice model of the chip and there is a particular boundary condition that I do not know how to apply in ABAQUS.
I want to make sure that a plane that is opposite the symmetry plane to remain parallel...
Hi everyone,
Hope someone can help me on this.
I am trying to model a slice model of an electronic chip that is undergoing thermal fatigue.
As this has been done frequently by researchers, I came across a lot of paper which state how they set the boundary condition of the chip. You can refer...
Hi all,
A simple question: How do you create a cone shape in abaqus? As far as I know, we can use a the loft shape, but I don't know how to do so.
Would greatly appreciate any help
Thank you
Hi all,
I am new to Abaqus and I hope someone can help me with an issue.
Basically I am doing a 2D analysis of the flip chip undergoing thermal fatigue (-40 degrees C to 125 degrees C).
Below is the material property data that I want to input for my underfill.
CTE1: 37.15
CTE2: 117.8...
