Dear all,
I have a problem modeling a contact beam models.
I am a beginning of the contact models.
I attached a very simple model made by myself.
Can anybody help me to check what is wrong with my model?
Thank you very much for your time.
Best Regards,
Dovil
FINISH
/CLEAR,START
*AFUN,RAD...
Dear Friends,
I ran a drop test using the Drop Test Module in ANSYS/LSDYNA. But it seems like I can only read the time history of the displacements, velocities and accelerations for CG and Lowest Point.
Does anyone know how I can read the time history data of DOF, Strains, Stress, etc., for...
Dear Friends,
I have a problem when simulation a drop test in ANSYS/LS-DYNA.
I was trying to drop a flat plate with linear elastic material properties, but the first rebound height is always as high as the original drop height, or even a little bit higher, but after two or three rebounds the...
Hello,
I was trying to add time history of the nodal solution of strains for Shell163 elements. Then, I got such error message:
The averaging done by the ANSOL command together with the RSYS,SOLU command assumes consistent coordinate systems for all elements used in the averaging. Shell...
Hello,
Does anybody know how to smooth the output variables in ANSYS/LS-DYNA.
I ran a drop test and got the acceleration of the gravity center, but the data contained a lot of noise, so I want to smooth the data. But I could not find any output variables in "Main Menu >TimeHist Postpro >Smooth...
