thanks for the help on an analyzer in previous post. i now find i have another difficulty coupling the sensors i'm considering and the equipment i want to control. the equipment expects a directly propotional 4-20 man signal but the sensor will yield an inversely proportion signal.
this is a...
sorry, cross posted this from electrical engineering froum, didn't see this measurement and control forum.
testing the current loop tester. how important?
i'm looking at the extech line of PRC testers that can provide source and sensor simulation for 4-20ma current loop, voltage measuring...
Need to replace a compressor motor that has always struggled with cold starts and melted down when the overload failed on a cold start.
I could have this motor rebuilt again. theoretically it was matched to the load in the day (1950s refrigeration compressor) Its a massive Westinghouse 5 HP...
hopefully if all goes well there are a picture of a steering link and mounting post below. this is from small gray market japanese truck from 1991. newer models use bearings, oldermodels used bushing constructed of two steel collars bonded by rubber similar to a shock mount bushing.
parts and...
I have removed an koyo spherical roller bearing and have the numerical designation from the race however this really only tells the sizing and not several other features that different manufacturers encode differently from other manufacturers and from their earlier designations.
I'm looking for...
Engineering, other than in the simple emperical sense, might be slightly overstating the work on this project but couldn't find another forum discussing rubber properties.
I am simply trying to fill a short piece of aluminum gutter with a moderately soft rubber that would cure into maybe a one...
