Hi,
My question is : how to use the view identifier as parameter?
For example :
Dim DrwDocument As DrawingDocument
Set DrwDocument = CATIA.ActiveDocument
Dim iParameter As Parameter
Set iParameter = DrwDocument.Parameters.Item("Drawing\Sheet.1\ViewMakeUp.1\Scale")
MyText.InsertVariable 0, 0...
Hi everybody,
i'm here again :D
i have a question and i hope that will be an easy one.
how can i format a sub text?
for example if i have a drawing text and i want to change it's value to : FormatedExample
i know that we can set the propreties of the hole text... but i want to know if...
Hi,
I'm currently working with CATIA V5, and i want to use Macros (VBA), but i have some problems!
My question is: how to change the text of a cut view? (see the picture)
http://www.hostingpics.net/viewer.php?id=65419615ca.jpg
i tried to use : myView.Texts.item(1) to access to this "text"...
Hi,
i'm in an internship, and i want to study the stress destribtuion with photoelasticity method, but my problem is that the material that i have is not homogenious but there ares two layers. I can do the measurement for the two material separated, but i dont know how to do that for my...
Hi,
i try to simulate a 3 points bending of a glass plate with abaqus.
force 1kN !
young modulus = 7e10 Pa
Poisson's ratio = 0.22
- the plate is square (30 cm) , thickness 8.72 mm
- i use 3D extruded solid
- for the load i can't create a line load so i replace this load by pressure in a...
Hi everybody,
first of all, sorry for my bad english, i'm not a native speaker.
I'm a new member on this forum, and i wish i will find a lot of good people here and that i can contribute in a positive way.
i have a problem with simulation of 3 point bending of a plate. i dont know how can i...
