Is this the correct way to GD&T this?
The dowel hole must have a tight positional tolerance to the center locating ring, and that it is in this orientation to the indicating edge (-B-) of the fixture. The indicating edge has to be orientated tightly horizontally to the pattern, but can have a...
I am not sure how to do this.
This is a fixture to hold a part for machining.
A locating spud in the center and a dowel will locate and orientate the part being held.
My intent is to have the .250 dia dowel hole kept relative to datum -b- very close.
The distance of datum -c- to the pattern is...
My intent is that the profile is good to itself along the designated length. I have added datums to help the inspectors, however, I'm thinking that I can achieve my intent with a profile FCF with no datums at all.
Comments?
I have a hamilton sundstand drawing with several diameters along an axis. The diameters only have feature of size tolerance.
No concentricity is listed for the multiple diameters. How is concentricity infered or controlled on such a drawing? What is the Y14.5 spec that can be used to answwr this...
I have tried several types of composite boxes, but none seem to describe what I want, or at least they dont look right to me.
My intent is to have the .375 dia have a position tolerance of .014 from datum -a- but .003 from centerline of datum -b-.
I also want an orientation tolerance of .003 for...
Question.
I have a .125+/010 dia hole that has a true position .010 with MMC.
Does that .010 true position apply at nominal hole size or at maximum hole size.
In other words, do I have .010 true position when the hole is at .135? Or does the true postion tolerance shrink as the hole gets bigger...
Hello,
See the link to the sketch
https://dl.dropboxusercontent.com/u/45474807/New%20folder/sketch3.jpg
The intent is to locate the start of the angle with a position tolerance.
The the tolerance of the angle can be greater, but its important that the angles perpendicularity is refined to...
My customer wants to orientate an angled hole to two datums, yet not use basic dimensions.
Not sure if he can do that with the way he is by using position toleranceing without basics. See link.
https://dl.dropboxusercontent.com/u/45474807/New%20folder/print_one.jpg
To try an meet the criteria...
