Hello All,
Sorry if this topic has been discussed elsewhere but I have been doing quite a bit of research on this topic and found minimal help. We have a compound thin tube with PTFE liner on the inside and Nylon jacket on the outside. The dimensions are below
PTFE thickness- 0.002"
Nylon...
Hello All,
I am trying to determine if the cabinet top plate will fail/rupture when lifted using the available 4 lifting eye-bolts. The weight of the cabinet is 1200 lbs and vendor supplied eye bolt has a load capacity of 500 lbs each.
I am not sure how to proceed with the analysis? Should I...
Hello Group,
I am working on selection of vibration isolators for one of our electrical cabinets which would be subjected to Sine sweep vibration test from 3 to 100 Hz (1 octave/ min for 2.5 hours) with peak acceleration of 0.7g(see attached pic for test plot).For preliminary analysis, I have...
Hello All,
I am trying to investigate robust methods of mounting electronic back panel inside an enclosure. The backpanel assembly weighs about 170 pounds and is subjected to 10G shock and vibration testing. In the past, we have used the following method
--mounting the panel on the collar studs...
Hello All,
I see that the Testing section (section#9)of API 17F standard specifically states below
"The following requirements are only applicable to subsea equipment"
My question is where can I find the qualification test requirements for the Surface equipment? This is strange because the...
Hello,
I am doing a research on the good reference books for mechanical engineers for electronic packaging. If anyone have already been using any good texts and can refer them to me- that'd be great.
Thanks
karthik
