I wasn't sure where to post this so I posted it in the Metal and Metallurgy forum as well (http://www.eng-tips.com/viewthread.cfm?qid=375377). I would like to anneal 321 at 1900F and what to know how it will react. Here's my case:
We've been thermal forming a piece of 6-4 Ti between an inner...
I wasn't sure whether to post this in the steel forum or not. I would like to anneal 321 at 1900F and what to know how it will react. Here's my case:
We've been thermal forming a piece of 6-4 Ti between an inner ring of 321 and an outer ring of 410. The 6-4 piece is about 9 ft in diameter (in...
When you use the Hole command in NX9.0 and dimension it in drafting, a standard text template is used. I was able to modify that by customizing the Hole Callouts in CUSTOMER DEFAULTS->Drafting->General->Drafting Standard. The result can be seen below in the attached picture. However I would like...
I have an advanced question that I'm hoping someone might have an answer or workaround for. I've setup a new drafting standards file and am trying to modify the Hole Callouts. I have specific Prefixes and Suffixes for the various hole features. I've found that when I have a THRU hole, it removes...
I've referenced this forum for quite a while but have never needed to post until now. I have to sets of data points taken from a CMM. When I select all of the data points in one set, it will number them in a difference order each time. I tried keeping the view the same but that did not work. I...
