Hello
I use ocean loading on vertical pile clamped at the bottom. I use PIPE289 element with wave loading. Resultan Morrison Force and Resultant Bending moment in bottom are the same a hand calculations. However, for pressure distribution along pile I get a triangular distrribution with base at...
Hello
Is there moderately easy way for hand-calcuations of the beam dispacement after plasticity occurs? My model is beam clamped on left and simply supported on right side. Force P in the middle of beam and plastic moment is Mpl (plastic resistance). I use elastic perfectly plastic material...
Hello all
Does anyone know where i can find Hardog's book "Strength of Materials'? I heard a lot of good feedback about it. And I am particularly interested in chapter 27 "plastic deformations". I analyse bending of beams beyond elastic limit and looking for some methods to check results from...
Hello to all
I am having troubles with ploting digrams of bending moments in Ansys APDL
I used this command for beam 188 elements:
etable,moz1,smisc,3
etable,moz2,smisc,16
plls,moz1,moz2,-1,1
It works fine, however, later I need to change orientation of beam's cross-section. I use command...
Hello
I tried to transfer results from static analysis in WB to APDL I transfered gemetry and model without problems. Then when i transferd Setup i got this error message:
"Update failed for the Analysis component in Mechanical APDL. The solver failed with a non-zero exit code of : 1"
I can't...
Hi all
I analyse buckling stability of a column in a static, nonlinear analysis. Bottom support allows only rotations (except torsional) and top one allows rotations and vertical displacement. To get initial imperfection i apply lateral pressure in the 1st step. In the 2nd step lateral pressure...
Hello all!
I will simulate complex beam-like structure to obtain ultimate strengh. The load will be increasing incrementally until structure collapse.I will model of course non-linear material for this.
My question is, what type of analysis to model failure of elements? Some beams will yield...
Hello all
I model a simply supported beam with uniform pressure and rectangular cross-section. I use bilinear isotropic hardening model (Et=0) There are two cases:
1st case: to achieve elastic limit (load q=8*sigma_y*(bh^2/6)/L^2)
2nd case: plastic hinge, q=8*simga_y*(bh^2/4)/L^2
For solid...
thread569-306821
Referring to the Thread (above) i want to ask about examples from verification manual VMMECH029
For 30000 lbf-in ansys returns exact solution, but for bigger moment it cannot converge. In the previous Thread it was recommended to set:
Element Control in Geometry - Manual...
Hi everone
For my Thesis I am suppose to conduct a pushover analysis of a Jacket offshore structure. I've done a bit of background reading about a pushover but I still dont know how to do it (to start) for a simple 2D strucuture in Workbench. As far as I know there is no predefined 'pushover'...
