I am quite new to non-linear analysis and NX.
I have a large displacement and contact problem and the solution fails at big loads while it converges at very small loads. Can I apply loads gradually so that the solution converges and if yes how?
I know that that there is a Load vs Time setting...
Hi,
I am trying to simulate a wire that is pretensioned and clamped on a ring and then loaded transversely.
I apply a negative temperature on the wire (I modelled the wire alone with axial loading and found the appropriate temperature) but the results are way off the expected results. I found...
I have some beam elements (rod) and a surface meshed with 2D elements. I have created mesh points on the surface where the 1D elemens nodes are. How can I connect the beam with the surface without using node to node 1d connection since it requires a section?
Hello,
I have a sketch that I want to add in an assembly in order to model it as a 1D element during simulation. When I click to add part and select the part (sketch), it does not appear in the assembly.
Thanks
