Hey Guys,
I am trying to figure out the best design for a new test bench and stuck with a interesting question. I try to analyse the resulting heat flow of a cylindrical specimen (bearing) with a diameter of about 90 mm. This bearing has in the load zone a higher heat dissipation than in the...
Hey Guys,
i've an interesting question for you! :) I'm currently designing a test bench with a focus on heat transfer of bearings. Therefore I've studied this topic and want to calculate following example:
A horizontal cylinder out of steel is heat insulated on the fronts (so that no heat...
Hello together,
I'm simulation a forming process in Abaqus Explicit. To avoid element distortion I used Ale adaptive meshing. Well now i did a DOE and it showed, that a higher Ale-frequency results in a higher forming force. Well if the frequency is higher, the elements are less distorted and...
Hey guys and girls,
i've some problem that i'm working on:
I've an explicit forming simulation and i want to use a butterworth filter to have a good force-displacement-curve.
To find out the best cut-off frequency of my butterworth-filter i found this in the abaqus manual:
"If you perform a...
Hi,
I'm trying to simulate a assembly process with a steel on steel contact. The problem is, that the lubrication is decreasing during assembly, and so the friction is way-dependent. Is there any way to modell this? I've tried to use partitions on one of the two contacting partners, but because...
