Good Day Experts,
We have a Separator with following parameters
ASME VIII Div. 1
MDMT = -29 °C
Shell 516 Gr. 70 Impact = Yes
Forged Hub Impact SA 105N = Yes
Elbow 2” 11.07mm thk. SA 234 WPB Impact = Exempted
UCS-67 IMPACT TESTS OF WELDING PROCEDURES
(a) Welds made with filler...
Hi Experts,
Could anyone please advise on the scope of Pressure Relief Valves for the Boilers constructed as per ASME Section I?
1. Is it mandatory that boiler manufacturer shall provide Pressure Relief Valves?
2. If reply of question 1 is yes then, Should it be "V" Stamped?
Appreciate your...
Dear Experts,
Can we use EN 1092-1 flanges in an ASME U-Stamp vessel?
Is there any provision in ASME Div. 1 to use these flanges and how to set temp-pressure rating?
Thank you.
Dear Experts,
I have couple of doubts regarding R-Stamp jobs.
1. Who decides whether R-Stamp is required or not for a U-Stamp vessel?
2. Found cracks in welding joint between stiffener weld and shell from inside with groove weld (Ground flush) and require repair. Its non-pressure part welded...
Dear Members,
Good day,
It would be really a great favour if anyone can provide a sample of calculations according to ASME SEC XII for ASME T Stamp jobs as per 2013 or 2015 edition.
Thanks in Advance.
Regards
Hi,
Good day,
If user specify corrosion allowance 1 mm for shell, toricone and 0 for top dish end. Its a vertical silo.
Now my question is what would be the corrosion allowance for the nozzles on shell, toricone and top dish end?
Does manufacturer of pressure vessel can use 0 for all nozzles...
