Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: alegna
  • Content: Threads
  • Order by date
  1. alegna

    Drilled holes in hollow rotating shafts in mixing application

    I recently had to replace an agitator shaft that was hollow. This shaft is essentially a SCH 80S 6" pipe, and rotates at a very low RPM (around 5 RPM). The shaft is about 8 ft tall. The original design has two holes about 3/8" drilled into the shaft, one closer to the bottom, and one up top. I...
  2. alegna

    Need Clarification on Kellogg Design of Piping Systems, Pipe Span Design - Chart C-18

    Hello, I am wondering if any one can clarify Chart C-18 (page 358) in the MW Kellogg Design of Piping Systems book? I don't understand the case scenarios and how the maximum moment and maximum deflection formulas are arrived at. Especially the difference between case 1 and 2.. they have the...

Part and Inventory Search

Back
Top Bottom