Hello all,
I am working on a Pressure vessel designed to ASME Sec 8 Div. 1 Code with design pressure of 120 barg.
The Vessel dia. is 1050mm and it has an ellipoidal head at top.
Piping configuration requires that the projection of nozzle at the centre of top head be kept to a minimum, and...
Hello all,
I am working on a vessel which is to be installed in a concrete pit. The pit will be filled with sand after installation of vessel as per local regulation requirement to prevent leakage of the process gas to outside atmosphere.
Vessel operating temperature is 230-C and the material...
Hello all,
I need a clarification regarding the application of UCS-68(b)
The equipment concerned here is Steam Airpreheater which basically consists of steam flowing in the tubes and air flowing across the tubes such that air is heated as it flows across the tubes.
The mechanical construction...
Dear all,
I am currently working on a Process heater which has Nitrogen as the operating medium and operating temp. is -49C. Required MDMT is also -49C.
Vendor has proposed to apply SA 333-6. However, as per ASME Section II Part A, SA 333-6 is impact tested at -45C , so standard SA 333-6 cannot...
Hello everybody,
I am recently working on an Exchanger for Lube oil service.
It is a very small exchanger and is to be used for cooling of Lube oil with cooling water. Shell ID is just 141.3mm and the exchanger body flanges and shell are made up of 5" pipe / ANSI B 16.5 standard flanges...
