Search results for query: *

Hi Guys!! How it's going? I hope you are ok! I'm facing with the flagepole connection warning and I don't how to fix it. The model consists in a box meshed with 3D elements and a wing made by two multilayer panels linked with 1D elements as you can se in the figure that I attach. This models...

Hi Guys!! How it's going? I hope you are ok! I'm facing with the flagepole connection warning and I don't how to fix it. The model consists in a box meshed with 3D elements and a wing made by two multilayer panels linked with 1D elements as you can se in the figure that I attach. This models...

Hi Guys How it's going? I hope you are fine. Here we go I'm studying a simple rod - crank mechanism as a simplification of a complex model. My idea is try to set BC's and analysis type in order to be able to set the same in a hugh model. But, I was not able to set them in femap, since I don't...

Hi guys!! How are you doing today? I hope you are fine I'm stucking in modeling a contanier made of polyethylene, more presicely high density polyethylene. I can't find papers o bibliographi where they specify which kind of material model match better with polyethylene type materials...

Hi Guys! How it's going!! I took an old model from a old workshop of abaqus in order to understand how connectors work. Four connectors were created in order to simulate the four shock absorver. The shock absorver was modeled with a cartensian and cardan connectors. It was set an elastic...

Hi everyone How are you? I hope you ok! I'm Domingo and I'm traying to mesh the geometry who *.sat file I've attached. In addition, You can see several images of the geometry and how was splited in different cells in order to use structural or swept meshed control. But, there exist some cells...

hi Guys Can be possible that Membrane plus bending stress is higher than stress intensity (Tresca)? thank!

Hi everybody!! I have a big problem. I need to use both, glue and surface to surface contact properties, but at the same time in a model. What can I do? Do I have to exporte the model and then rewrite .dat file? I know that NX. has an option for these questions. Regard!

Hi Guys Is anybody know if Femap has Tresca criterion? Because Femap has Von Misses criterion but I do not find Tresca criterion. Thanks!

Hi Guys I need to verify two saddle according to ASME Sec III NF. The idea is verify the saddle by fea (Design by analysis) (I already have a fea model of the pressure vessel with its supports) and on the other hand, verify the supports with design by rule according to ASME Sec III. The saddle...

Hi Guys I would like to know how to identify and calculate the secondary stress in a pressure vessel using FEM. Thank!