Hi,
I am a small time furniture manufacturer and am looking to make a design in low quantities formed from 5/16" steel plate. It has complex curves on it, and I hope to form it in a hydraulic press. I have had some success already but have been having troubles designing the dies to use. I can't...
Hi,
I have a design for a floor display that is made of a bent 1" tube in a 12" diameter that sits on the floor. I am trying to find a foot pad for this and would like to avoid drilling into the bottom. Does anyone know of an off the shelf rubber or felt pad that has a negative cylindrical...
Hi,
I am designing an injection molded part that has a couple tricky areas. All the areas shown in green below can have no draft. All the other surfaces can have 2 degrees or more. Currently I am envision the mold opening and closing as the two arrows indicate in the first isometric view. The...
