I'm having problems in determining the quality of the mesh of a certain model. As can be seen from the attached file, the upper elements that should have the same quality, they do not have this feature.
Numerically they have a value of the Jacobian of 0.4, but the colors are different...
If a frequency response analysis on a modal basis is done in a certain range (eg. 0-5000 Hz) how many vibration modes to be calculated so that the analysis is valid?
You can use a number of ways to recruit the 90% of the total mass, although this does not cover the entire frequency range?
Hi,
I created some connectors in a model but when I copy the mesh, are copied only the regions linked to connectors and not the connectors. Is there a way to copy the connectors?
Regards.
I created this model with four plate elements that meet at the center. When viewing the thickness, the elements are interpenetrating, and consequently I note an undesirable increase in weight. It would be possible to keep this geometry avoiding the extra weight...
