Morning all,
Just wondering what the consensus is on the below.
I can't say I've come across this before - I've taken delivery of a quantity of machined and anodised parts, however - have received in excess of the ordered quantity, but a number of these have not been through all the steps of...
Evening all,
Just a quick question on general opinion and concensus.
Generally, does one specify part tolerances as before or after surface treatments such as anodising? Clearly this is important as a tolerance in the range of a few to tens of microns, could potentially be well out of spec due...
Morning all,
Long time lurker of these forums, first time poster today however.
Currently got a little bit of an issue, I am currently reworking an existing design in which a parallel pin drops into a parallel hole within a sliding component, used to lock it in place.
I wish to remove play...
