I have a shaft rotating under a load and I am trying to simulate the stress that occurs in the shaft when a brake is applied through a coupler using a woodruff key. I have done it 2 ways and am seeing somewhat similar results but I don't know if the 2nd way is accurate.
Left Image: I apply the...
I have a disk that is inserted in a cylinder. A square sleeve will be inserted and welded to the square bore of the disk and I am trying to center the hole on the disk. Is a position tolerance the best way to do this? I have read that you can use position with any feature, not just a circle...
I have been working with an injection molding company in Taiwan for several years. They are not ISO so I am curious as to the reasoning for the additional drawings they create. We send them 3D models and drawings of injection molded parts as well as 2D drawings of overmolded cables. They...
I have a hollow cylinder rotating at about 2800rpm max. I welded the bottom of a small tab to the end of the cylinder, and want to find the force acting on the tab that would bend it away from the cylinder at those high speeds. Any thoughts?
Hi there,
I am trying to create a draft on this part. See picture below. I have used the draft feature before but I cannot figure this one out. Any help is appreciated. Thanks!http://files.engineering.com/getfile.aspx?folder=e3c99c5e-0ffe-4e75-b30e-b1ad9aa791e1&file=DRAFTQUESTION.png
Hi there,
I have a drum that needs both faces of it perpendicular to the bore of the drum. I am wondering what the correct location of the feature control frame is so that both faces will have the tolerance. I am only assuming that putting the feature control frame pointing to one face means...
