I would like to start integrating some GD&T tolerances into drawings, and I figured I would start with symmetry and true positioning
for features that I do often.
One concept I am trying to figure out is how to specify a hole should be centered within the width of a part.
Here the width is not...
Such as devices like the one below.
Link
If you check out Page [5 of 10] you can see a diagram of the device.
Pins 6-8 and 9-11 are all mounted underneath.
I had a small board made up using the recommended pattern in this document.
I have tried using solder paste, by placing very small dabs...
I am trying to find reference for the correct weld symbol and annotation for drawings to use for the following weld:
Purged - Sanitary , Tig Weld
Used on 1.5" stainless tubing.
Would someone know what the proper symbol is?
I have attached a picture outlining a setup that I have a question about.
In this setup, there is a load that is being tilted around a pivot point. It's center of mass is located a bit off body, shown by a dot in the picture labeled CM.
Space being an issue a proposed solution was to extend a...
I am looking to research the topic. The pnuematics in question would be simply a valve and compressed air system.
I have been searching for such documentation but have been hard pressed to find what I am looking for.
I was hoping either someone might know of a company that might handle such...
