Is it allowable to pressure test above a WOG rating? For example my MAOP is 540 psig, thus I am using 600 WOG parts. But for my pressure test I will be testing at 810 psig to 864 psig. I will be exceeding the WOG rating of 600 during the pressure test, but I will never be operating that high...
Hi, I am considering crossing a steam line with a HDPE pipe used to service natural gas. I plan on using a steel casing to help protect from the high tempertures produced by the steam line. Does any one have experience with this or is there any publications that provide guidance on this. I am...
Can anyone refer me to a method or standard for calculating pipe stress when applying a external pressure to a pipe?
For example, I am installing a fully encompassing spherical fitting around a existing run to create a new branch. After welding the spherical onto the existing run I am suppose...
Can someone explain the prefix letter on SMYS ratings. For example I have always seen pipe with an X (i.e. X42, X52). But I have seen fittings listed as F52 or Y60. What is the difference between the prefixes?
Is there a standard for calculating Actual Gas Flow for diaphragm meters? I am aware of AGA standards for rotary, orfice, ultrasonic and corlios meters but I am unaware of anything for diaphragm meters.
Can you mix Sch 40 and Sch 80 pipe/fittings? For example I am having a hard time finding 3/4" Sch 40 API 5L FBE Seamless pipe, but I can find Sch 80, Is it okay to upgrade to Sch 80 and intermix with Sch 40, or will the fittings and pipe not connect properly?
Can someone briefly descibe the differences between butt fusion and electro fusion. My understanding is butt fusion uses heat to connect the butt ends of pipe while electro fusion runs electrcity through a fitting connecting two pieces of pipe to connect the pipes with the fitting. Is it...
When specifying flanges, is it possible to abut different ANSI ratings to each other (e.g. 150# abutting to a 300#)? Or will there be problems with the bolt pattern, gasket, etc., not fitting correctly?
After using the Darcy Weishbach equation to calculate head losst through a pipe, can I then take that head loss result and apply Bernoulli equation to calculate the new velocity given the head loss? If I do it this way I seem to get velocity in=velocity out, but this doesn't seem to be right...
How would you calculate the pressure drop through a reducing tee (2" run with 1" branch)? I can calculate the pressure drop through a tee using Darcy Weisbach equation with an equivalent length for the tee, but I'm not sure how to treat a reducing tee. I suppose I could just calculate the...
