I had another vale go out on the beast, although I programmed it in the PLC, I know little of hydraulics.
Here is the value Part number from Rexroth: 4we6d52/ag24ndav
The diagram is here:
https://photos.app.goo.gl/hoXiUgd1zxccNB7K2
It controls one ram. I believe it's a 4 port, 2 position...
I have a control panel with the 30mm holes with the notch. Pilot switches/lights. I need a blank to fill in a spot where there is no switch. My google searches are coming up with blank plates with a hole in it for labeling...
And suggestions?
This valve is from the 70's. It takes 24 volts DC, and it opens one way. There are 2 valves on the Ram, one goes out, one goes in. Same plate on both. The electric part of it shorted down to .6 ohms, so it blows the fuse, therefore I disconnected it and have a human running it manually with...
I'm trying to drive an LED so that it shows 3 different states.
This thing goes in a circle, and there is a limit switch at the bottom. (Hydraulic motor spins a gear) When you press Start (X1), the motor runs (Y1) until the limit switch (X2) is hit again. (Can't use rising because of bouncy...
I've got the ram moving forward to limit switch (based on physical user switch), then when switch is reversed, ram goes back to starting limit switch, as long as user holds in the switch.
[ ]-[/]-( ) Easy
I'd like to automate this so a momentary switch makes it latch, drive to limit, pause...
