Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. MecEngSelli

    Heat Exchanger design problem

    Good morning Everyone. I'm developing and evaporator with Ø2580mm and 1760 tubes of 15.000mm, it is vertical and the materials of the head and tubes are AISI 316 and the shell is ASTM A 285 Gr C So when i run the calculation it appears the following message. ASME: Shell side MAWP 0,14 kPa <...
  2. MecEngSelli

    Appendix 2-6 for COMPRESS

    Good morning, I designed a flange where the bolt's exceed the spacing of 2db + t, in this case, following Apendix 2-6 i need to apply equation 7. Where can i find this option in Compress? Thank you!
  3. MecEngSelli

    ASME Flange Fabrication

    Good morning, I need to fabricate some ASME Flanges B 16.5 and i can't find where in the ASME code it says if i can build from a whole plate (one single disc) or if i can fabricate with crankshaft method. The diameter i must build is something near Ø600mm Can anyone help me point the area...

Part and Inventory Search

Back
Top Bottom