Dear All,
When performing a elastic-plastic ratcheting assessment in accordance with the Div2 Part5, I am checking the maximum plastic strain magnitude at each pressure cycle on integration point to check that if plastic strain progress.
The question is that the software is providing seven...
I design a Div.1 combination unit column with two independent pressure chambers in which intermediate ellipsoidal subjected to the upper chamber design internal pressure at concave side and bottom chamber design internal pressure plus FV pressure at upper chamber. With these design pressures at...
I cannot verify NozzlePRO calculated SPL & SPS stress limits at the creep temperature ranges.
At the creep temperature ranges [where value of S is governed by time-dependent properties], NozzlePRO takes yield strength into account for the calculation of SPL and SPS stress limits.
However...
