Hi there. Thanks for your attention.
I'm mechanical design engineer (maybe that's the root of the problem - I'm not that familiar with electrical realm of the question) and I fall short to find any plausible answer to the problem, described below, that perplexes me.
Since I'm working on a design...
Hello there, guys, thanks a lot for your attention.
I use NX 2212, and I was searching high and low to override the default shortcuts for "Make ..." commands (e.g. Make Coincident (X), Make Collinear (C) etc.) in Sketch Task Environment, which are also available from Sketch scene bar, but every...
Hello there, dear colleagues. Thank for your attention.
I'm struggling to establish Debian 11 Linux workstation with NX12.02 (native Linux). In order to utilize the functionality of part families I need the XESS spreadsheet, and that's when the problem arises. As far as I understand, AIS...
Hello, colleagues. Thanks for your attention.
As mentioned in thread561-335093, the Thread tool produces somewhat ambiguous results regarding to the tapered threads, at least when talking about NX 10 or earlier. Summarizing the content of the above mentioned topic, Thread tool is applicable...
Hello, experts.
I am using NX 10. Suddenly (actually, today), sheet metal module starts to act weird. I create a sheet metal part, contained some export-to-sheet-metal features, flanges, bends, etc.; then I create a flat pattern and take an attempt to place the drawing view of that flat...
