Hi Guys,
I'm on the design of an Air Cooled Heat Exchanger as per ASME SECT VIII Div.1, 2015. This design is based on an existant Air cooler that need to be replaced. I Already designed the Headers per appendix 13 but I am little bit lost on the selection of plug for the plug sheet.
The...
Hi Guys,
I'm working with ASME Section VIII Div 1, 2015 Ed and it has caught my attention when on the table U-3(Year of Acceptable Edition of Referenced Standards) I did not find ASME B36.19M (Stainles steel pipe).
a) What does this mean?
b) Was ASME B36.19M (Stainles steel pipe) on Section...
Hi guys
I'm trying to make comparisons with Sec VIII div 1 2015 and Sec VIII div 1 2007 add 09. I want to know the difference con UG-34 (g) between both editions but I don't have the 2007, add09.
Can somebody help me to identify the difference?
Hello,
Basically I don't understand the figure UG-34 (g). I am not clear on how is the joint and how should be perform the welding according to figure UG-34 (g).
Please check the yellow rectangle on the attachment. Is that a J-type groove? is tw the land? If is the land it looks so big that...
I want you to help me how to select an MDMT for a duplex stainless steel SA-182 according to Sec VII div 1. When I have a carbon steel is easier to me but when I go to part CS but in this case I'm a little lost when I go to UHA. Which parameters of the design I need to know the MDMT?
As you...
I want to know if I can find this swage (See attachement) in any Asme Standard. In B16.9 doesn't appears. I want to order this item but before order it I want to know if there is a standard for it or other name...
Hi guys,
I have a design per appendix 13 but I want to know if I can model it on COMPRESS or other software. Ithe answer in COMPRESS is yes, I would like your help.
Thanks, regards.
Hi guys.
I have a doubt here and I hope you can help me.
I am working on a design of a tubesheet and the client wants to be made of SA-240 (Stainless steel)which the product form is plate according to ASME SECTION II D. All tubesheets I've seen are made of forged steel and that's why I Looked...
Hello,
I have a vessel with an outlet arrangement attached to the bottom head in which 3 nozzles (NPS 3 each) are connected with an B16.9 Cross (See the sketch attached). I have 2 ideas to model the cross in compress.
The option A is to attach a pipe no the main nozzle necks but compress will...
Good Day,
I am working on a vessel with weld overlay on the nozzles. I have doubts on how to model the weld overlay on COMPRESS. It is ok if I only add a lining on the menu "ATTACH" or I just should ignore the weld overlay and use CA=0? Which is the most accurate way to model a weld overlay on...
