Hello,
Just wanted to check my understanding of NACE MR0175 correctly.
Am I right in saying NACE MR0175 is for materials to be used in sour environments that make the material susceptible to suplhide stress corrosion cracking?
Therefore, considering 17-4PH Precipitation Hardened Stainless...
Hello,
I've got a question as to how the threads would fail when considering a cylinder with threaded end caps when subjected to internal pressure (see top drawing on attached pdf)
Would they fail as the second drawing, completely shearing the internal threads of the cylinder (shaded in black)...
Hello all,
Just wondering if anyone had any experience of FEA of metric screw threads.
For example 2 engaged threads M50 x 3 Pitch with a force applied to one end.
Looking into failure due the yielding.
Could anyone point me in the direction of any information online as my current searches...
Hello Prex, TGS4 and anyone else who may be able help!
From reading several other posts you both seem highly informed when it comes to stress linearization and was hoping you could help me out a little...
I am completing an FEA analysis to support an ASME VIII Div.1 vessel by completing the...
Hello,
I am currently attempting stress linearization on a model of a cylinder with internal pressure applied.
The model is axis symmetric and only a 1/4 of the model is modeled and the symmetric fixture is used within Simulation.
My section plot cuts the model in half again (effectively...
I am currently looking at an F.E.A report that follows the methodology of ASME VIII Div. 2 part 5 to verify an ASME VIII Div. 1 accumulator vessel.
The report mentions two factors that I can't find the origin of;
Weld Efficiency Factor
Casting Efficiency Factor
Could someone please...
