Hi everyone,
I'm being asked to look for a US or european standard for welding 2 rebars as you can see in this video:
Link
The method is called Gas Pressure Welding and in some cases they use another one called Flash Welding. In my case I need a method suitable for site works.
In the same...
Hello,
I have a composite column CHS900x40 that needs to be protected for 2 hours.
The calculation method exposed on Eurocode is not applicable for columns with D>400mm. The solution proposed by the EC is either protect the steel for T=350°C or do a thermal calculation (fancy software). I've...
Hi everyone,
Does anyone used a VWTT to asses preliminary Wind loads for a complex building?
I know there is Flow Design from Autodesk and HyperWorks from Altair but I've only used the first but i'm not very sure about the results.
Thanks,
David
Hello everyone,
Large open question:
If your company was able to give you a lot of money to launch one or more R&D programs focused on structural engineering, what subject would you like see on the list?
Hello everyone,
This is my first post.
Is it possible to run a plastic design of a shell (steel) under flexure on SAP2000?
I want to try to avoid the use of the yield line method with complex geometry plates (holes and angles).
I know that this analysis is possible with SCIA Engineer 15 but...
