Hey Guys,
I have an ABAQUS Model, where I want to constrain 2 parts together (a thin metal plate and a U shaped piece of metal). Before I can do that, I have to bend the metal plate, so it fits into the U-shaped part. During this deformation the 2 parts should not be constrained together. After...
Hi guys,
I have a problem with analyzing in Abaqus. I want to put two already analyzed (deformed and with residual stresses) plates into one unanalyzed U-Part like the following picture.
The little yellow circles are the tie constrains between the deformed plates and the U-Part. I imported...
Hi guys,
I want to put together two parts from two different Abaqus models. One of the parts was analyzed and now has residual stresses and deformations. I want want to assemble this deformed part with its residual stresses to the other part. Therefore I wrote restart data from the original...
Hi guys,
I am quite new to Abaqus, so this should be an easy one I hope.
I have two different finished models in Abaqus. The one is an airfoil (without any analyzing) and the other one is a thermally cured fiber reinforced rectangular plate. I performed one analyze step on this plate, in...
