Hi Team,
I would like a heat exchanger/water cooled cylindrical section, similar to the attached image, but so that it is split in half i.e can be opened for cleaning/inspection etc...
I would like to understand if you have seen something like this already, before i "reinvent the wheel"...
Hi all,
I have a large HMI control panel that needs to be used at all points along a long conveyor belt. approximately 10 metres. I would like to mount this HMI onto a rail that runs the length of the conveyor, with a linear bearing to slide this HMI up and down the rail (therefore conveyor)...
Good afternoon eng-tip users,
I have a quick question about coatings. Currently we have a steel fixture uswed for holding sheet metal as it gets sprayed with telomer and then baked in the furnance. This fixture becomes heavily coated with Telomer and requires quite abrqasaive cleaning, usually...
Good afternoon eng-tip users,
I have a quick question about coatings. Currently we have a steel fixture uswed for holding sheet metal as it gets sprayed with telomer and then baked in the furnance. This fixture becomes heavily coated with Telomer and requires quite abrqasaive cleaning, usually...
Hi,
This is my first post as eng-tips.com so I hope i have posted in the correct category,
Anyway, I am looking to control the tension in a steel wire that is being unwound from a coil, passes over two pulleys and delivered into a machine. The power for the unwind of the coil is coming from...
