For a simulation, I have to select the inner surfaces, with some surfaces Creo 2 does some weird stuff again.
As seen in the image the surfaces parallel and on the same level are also automatically selected.
With a cylinder block by a wall, it selects also past the edges (not seen in the...
Hi,
I am getting a little frustrated with how Creo 4 behaves right now, especially after the below issue, so I hope one of you has a solution.
Now I have a part that I saved last week after adding a fillet feature that had many lines/fillets in it and Creo gave me a traceback error and...
Hi fellow engineers,
For an application I need to protect a connector from temperatures up to 700°C from conductive heat transfer.
The connector support is metal on a metal pipe of which the latter contains hot air with above temperature.
Between this support and the connector I want to put a...
