AISC 325-17AW Steel Construction Manual Table 1-7A Workable Gages in Angle Legs shows fastener spacings for structural angles. I understand that this "Workable Gage" refers to the transverse center-to-center spacing of fasteners that will "work" so as to meet edge distance and space...
thread561-256292
The answer for me, using NX12 was to got to Part Navigator while in Drafting mode.
Rt-click on each view and click properties, Attributes tab.
It the column VWLETTER or VWLETTER_DISP is where I found the an "imported" Front view lettered "A". Why Siemens WHY?????
Blanking...
I have a simple pin that is not intended to rotate in its hole but needs to be a close tolerance fit.
I am undecided if I should callout out Total Runnout or simply straightness, and by straightness I mean the Axial type, i.e. straightness applied to the diameter callout not pointing at the...
Is it possible to perform a Fatigue analysis with the Generative Structural Analysis workbench?
That is applying low-level load cycles and application of some metal fatigue theory.
I only see Static Case, Frequency Case, Buckling Case, and Combined Case.
There is also Static Constrained...
Can someone explain the logic behind ASME 14.5 1.6.2(a) which states:
1.6.2(a) A zero is not used before the decimal point for values of less than 1 in.
To the contrary 1.6.1(a) for metric units (millimeters) states the opposite:
1.6.1(a) Where the dimension is less than one millimeter, a zero...
This is a very basic question but still a source of confusion for me at least.
More annoying than it is critical to know, but here it is:
Shigley & Mitchell Mechanical Engineering Design 4th ed. P339 refers the dm = "Mean Diameter" of a screw thread.
What's not clear in my old 4th edition is...
