I'm designing a new gearbox that operates submerged in water, and working on calculating how much oil I need, and if I need a breather for the vapor pressure buildup (hoping not).
What references exist for determining oil type and level required?
What references might you have for determining...
Following up from this conversation: thread821-159659
Can a cylindrical roller element bearing support a moment load?
I would assume the calculation would be the assumption of a point contact at the ends of the roller from a radial force couple. The equivalent radial load being that due to the...
I've got some bearing bores that I want some tight tolerances for proper interference fits. Should I have the machinist mask the bore prior to anodizing, or specify tolerances on finished part, fully anodized?
I guess I'm wondering how to account for the plating thickness (since it can vary)...
I don't see this in practice much so I wanted to know: if anyone as experience with using a split bearing cap to make a housing for a rolling element bearing. In particular I'm looking to use a relatively narrow section (6903) deep groove ball bearing with a rotating shaft for oscillatory...
I've been digging through the catalogs but have had some difficulty finding the allowable axial misalignment of a needle bearing (drawn cup or otherwise). I've got an oscillatory application (~10degrees motion) that has limited radial space, and requires a yoke to reach to either side of the...
