Hi,
What type of seal would I want if I need a seal in which i can slide a shaft through, creating a seal on the outside diameter. I would then like to be able to remove said shaft (maintenance) and replace with another shaft (same size) and again be sealed hopefully without replacing the...
I have a plate 70mm x 70mm. There are 2 points of force being applied to the plate at 6.5 N.
From this can I calculate a pressure applied to the plate in PSI?
Attached image.
Thankshttps://files.engineering.com/getfile.aspx?folder=1c37896d-5768-48c7-adab-df0bbb51ae37&file=PLATE_FORCE.JPG
Good Morning,
I am looking for some advice for a type of valve or design.
I have a sealed machined box style enclosure. It contains liquid. The enclosure has 2mm walls all around, i.e. top, bottom, left and right. The enclosure has a overall height of around 45mm. So with the top and...
Good Afternoon,
I have a question regarding detailing welds that have to be sealed. So say for example the weld size I require structurally is a 5 single bevel butt weld. Now this is required to be liquid tight also. If I add 'SEAL WELD' reference will this compromise the weld strength by...
Good Afternoon,
Could anyone advise me on an anti - static hose (10mm ID) which gives good flexibility & elasticity i.e. Silicone? Temperatures of 0 up to 70°C. It needs to fit onto hosetails.
Any help much appreciated.
Thanks
See the attached image. How would you dimension the top faces of this part to ensure faces are kept level relative to each other?
Would you use a parallel geometrical constraint or just linear dimension each face from the base?
Thanks
Hi Everyone,
I am looking for some inspiration.
Any ideas on what to use to make a quick release lid for a container like shown. (see attached).
I am looking to use something that doesn't require any tools. The lid needs to be removable from the box so a standard hinge and latch wouldn't...
Good Morning.
I was after some ideas and / or advice regarding the following.
See attached image of a typical sheet metal box. 2mm thick and seal welded in all 4 corners. There is only 1mm space to the outside of each face.
Now the problematic area. The top 4 edges. These are edges of 2mm...
Hi,
I have a question regarding fitting a steel rod into a plastic handle.
For instance, if you was making a prototype of say a screwdriver, how would you connect the metal driver to the handle? I am hoping to not have to commit to tooling cost just yet so looking for a simple solution for a...
Good Morning,
I have a question regarding sealing on a fabricated square face.
The part is formed / fabricated from sheet metal (2mm). Do you think it is feasible to create the flatness & surface finish on the green face to achieve a seal using a flat face gasket? Can you control the...
