In our parts we create fins for heat dissipation on radially rotating parts. I created a new body and inside this body are two pads that define the two fins (one is slightly shorter than the other). I then create a few other features to trim both fins or modify them (such as fillets, draft...
I have used Catia off and on for some time now in a limited capacity, but am going to start working much more in the near future. So not a total newbie, but also not a seasoned expert. I have been a SolidWorks user for many years and realize (obviously) that they are not the same software...
We have many instances where runout was used on a flat surface. The basic premise is the engineer at the time was attempting to control the "wobble" on that surface (basically perpendicularity)and back in the day TIR was the goto for prints. If given the choice I would write a request to...
