Hello,
I'm encountering an issue on one of my drawings similar to that shown in the picture below (see also this link: https://www.tec-ease.com/gdt-tips-view.php?q=170#:~:text=Although%20changes%20in%20size%20are,the%20runout%20could%20be%20large.)
The size tolerance on the shaft is smaller...
I was looking at one of our drawings and we have a drawing for a timing pulley that requires the centerplane of a particular tooth to be aligned to the centerplane of a keyway within 0.5 degrees. Currently, the requirement is that the centerplane of the tooth is aligned to the keyway and not...
Hello,
I have a part I'm detailing where a large, flat surface is my primary datum (A), and I would like to set two approximately (not quite, due to draft angle) perpendicular tabs as my secondary datum. The tabs have a significant gap between them. I would like to treat them using the...
thread562-302300
Hello,
In the thread linked above, Beeachcomber mentioned a workaround to move a part (like a bushing) from every instance of a lower assembly into the upper assembly. Beachcomber, can you or anyone else please provide this method?
Thanks!
A picture of the welded assembly in question is attached. The holes I refer to are circled in blue.
I came across thread1103-398706: opposing face datum holes when investigating a similar problem, and found it very informative. I have a question about my application, as there is an important...
