We have an enquiry for a very large axial nozzle check valve (>60in) to be manufactured from carbon steel. The customer has specified a relatively low design pressure (~8barg) which is well below the material specific ceiling pressure for a 150# valve (ASME B16.34). The customer has specified...
Hi folks,
I am currently calculating the required thickness for a a custom blind flange (test plate) for our internal hydro shell test (1.5xDP). I normally refer to 12516-2 section 8.2 to determine the thickness (hc) either when the plate is with or without concentric opening (8.2.2 & 8.2.3...
Hello,
We have a requirement to test a number of large nozzle check valves (60"-300# Series B) shell and seat test (1.5xDP & 1.1xDP respectively). We need a pair of blind flanges to seal the unit for testing, we have a pair of plates (9in thick) made of Ductile Iron A395 60-40-18.
I have done...
I've used this forum a number of times, but I've taken the plunge and joined as I have a question I'm struggling to answer...
I've done a number of searches on this forum about the use of C95800 as a valve body material... As this material is not listed in either ASME B16.34, ASME II Part D or...
