I inherited this project, and a lot of the prep work was not done before the device ended up on our floor... (device works by dumping the parts and ceramic media into a basket with filtration holes in the bottom. You shake the basket until all that is left is the parts.
We have deburr...
I have a quick question... I have a process sheet with the GD&T similar to the one above. The process is a fine grinder. We grind one side, and then flip it and do the other side.
From what I was taught the bottom is how we are supposed to call it out. Also, both of these don't seem to...
I have an issue with carrier rings for a large lap table. They require a 45 degree chamfer in order to push the slurry on the table. Problem is that it's approximately a 16.5 inch alumina ring, and we do not have an grinder with a big enough chuck. We do however have a CNC lathe (with turret)...
