Hi,
I have some large forgings I need manufactured in Inconel 718 (approximately DIA1000mm x 200mm with a bore of 700mm). Can anybody recommend a supplier that may be able to supply these. We are based in the UK but anticipate having to use a US supplier or somewhere in the Far East.
On the...
Hi,
I have some large forgings I need manufactured in Inconel 718 (approximately DIA1000mm x 200mm with a bore of 700mm). Can anybody recommend a supplier that may be able to supply these. We are based in the UK but anticipate having to use a US supplier or somewhere in the Far East.
Thanks
Hi All, I have a materials question with regards to the EN 13480 code. We can't get round bar in the diameter we require in P355 to make a tube with flanges on the end. The flanges have already been manufactured in P355. Is it permissible under the EN 13480 code to weld Stainless steel to Carbon...
Hi All,
We're having a part for some pipework made which will be sandwiched between 2 flanges, it falls into PED cat 2. It is 320mm thick and has an OD 1240mm. Ideally it could be machined from plate or round. Looking at EN 13480 - 2 it looks like permissible plate materials are:
P275NH...
Hi All,
I'm new here and new to PED. The summary of this question is: I have a vessel I'm designing that has some tapped pads welded to the side to allow some legs to be bolted on. I have to jump through hoops to get stuff welded to code, i.e. do an individual drawing for each part, have each...
