Hi everyone!
Absolute beginner here. Have mercy!
I`m setting up a static structural analysis for a simple trailer. The setup and simplified trailer schematic is shown on the attached pic.
At the momement I`m using the axel bores to apply cyindrical constraints. But the problem with this...
Hi All
Say you have a part like the one on the attached pic. Basically it`s a single part that is manufactured by laser cutting, bending and welding (red corners on the pic). If one would create a drawing for the part, would that drawing be considered as a part drawing or a welding assembly...
Hello,
Back in engineering college when we drafted by hand we used the following designation system:
If an assembly designated as XX_01.00 has three parts, then they are designated as XX_01.01 (part #1), XX_01.02 (part #2) and XX_01.03. (part #1). On the ASSY drawing the item numbers match the...
Hello,
The length measuring accuraccy for CMM-s is stated with parameters E0,MPE and E150,MPE according to ISO 10360-2. Can someone please clarify:
1) What is the practical diffence between parameters E0,MPE and E150,MPE?
2) If for example the E0,MPE for given length equals to ±3.6 µm then is...
Hi,
I`m currently using SOlidEdge ST9 and creating a part drawing in draft. I want to apply a position tolerance to a hole and also show the hole diameter (with tolerance class) above the FCF as stated in ISO 1101. How to put the hole dimension above the FCF? The situation can be seen on the...
