Hello Everyone,
I am facing an issue related to hammer union Female sub thread identification for a higher size as well pressure rating.
I require 6" Fig 2202 Sour Service Female Sub. Can anyone suggest the ACME Thread size for the same.
right now I have selected the 6 11/16 - 5 ACME 2G as...
Hi Everyone,
I am looking for your help to evaluate the 6A chokes with lower temperature.
API 6A temperature standards are defined the lowest temperature which go no further than -60°C (-76°F).
here i have a problem with a project which is having -101°C as minimum temperature for chokes that...
Hi Everyone,
In API 6A, for chokes section, there is a clause for "Adjustable chokes indicating mechanism". as per the clause, whenever the chokes supplied with manual hand wheel actuator,
---quote---
chokes should be equipped with visible orifice-area-indicating mechanism to define the...
Hi,
Can anyone help me to find out the NACE MR0175 requirement for LF6 materials??
since this material is not listed in the NACE MR0175.
Dinu...
There are no secrets to success. It is the result of preparation, hard work, and learning from failure.
Hi
i just wanted to calculate the clearance CV for control valves.
i have calculated the cross sectional area for plug OD and cage ID and K factor for the cage.
Herewith i have tried with actual CV calculated formula
CV = Area * K factor
But i couldn't get the exact clearance CV values...
I Understand, when Ni, Cr, Mo, and other alloy element contents consist of less than 10.5% defined as low alloy steels.
Can anyone help me to find the list of low alloy steel material grades(ASTM/SAE/AISI)?
Is there any cumulative grade list for the same?
Dinu...
There are no secrets to...
