I have a model which contains some parts having initial stress. I defined this initial stress by using predefined field feature. However, I took an error 'Initial conditions specified on 1 elements are illegal for those elements. The elements have been identified in element set...
Hello,
My model is multistep (2 step) analysis (standard). In first step, a part is bended and then it should be bonded to other parts in second step. So, in order to create the contact in second step, I have to use contact pair because tie contact constraint cannot be deactivate/activate...
When I am running my model in Abaqus, I took 'ABAQUS/standard rank 0 received the SIGABRT signal' error in different time step in every running job. What is the reason of it? Could you tell me the reason of it, please?
Note: I took solutions for different load directions with the same model.
Hi,
I have a vertebra FE model in Abaqus. I can probe the related stresses but I don't know how to measure total pressure in nucleus of an intervertebral disc. Is there any way for this?(For example, I can obtain total facet forces from history outputs)
Best regards
I could run an overnight job simulation without the job getting aborted but now I couldn't do it after an improper shutting down. I try to run an overnight simulation but the job kept getting aborted due to error "session has been idle longer than 3600 seconds, disconnecting from Abaqus License...
Hello everyone,
I'am trying to form a vertebrae model and I have a orphan mesh model of a vertebrae (C3D8R). I directly assigned different materials to outer and inner elements (separated with sections) and I could solve it without any error. Although the inner elements have a small young...
thread799-384267
Hello,
I try to create a nucleus pulposus model and how can I define my geometric model as a fluid cavity? When I try to define a fluid cavity interaction, I couldn't see the volume surfaces of the nucleus in the set list. How can I create and put the fluid cavity set in the...
Although I assigned section to Orphan mesh according to sets of Orphan mesh, I took errors of without any material assignment to this part. Even the section assignments are shown in part tree of the related orphan mesh. What might be the reason of it?
