Hello,
I want to use the topology optimization feature in my static loading case. However, I would like the program to replace material properties for elements that take extra loading with a special cement, and I would also like these areas of material replacement to be of a certain geometry...
Hello,
I am having trouble figuring out why one of my elements is acting strangely. I am working with a heterogeneous bone model simulating a compression test. After about a third of the step, one of the elements begins spiking out. The element is located far from the analytical rigid I am...
Hello,
I would like to isolate elements above or below certain stress/strain levels. This was easy to do in Hypermesh, where you can use a slider that controls which elements are seen by revealing clusters of elements based on the slider position. Is this possible in Abaqus 2018? I found...
