I have an assembly that when I grab one part, the attached parts follow but the parts that are attached have a "set" range of travel. Inside NX (12) you can just pull the parts past the "max" range of travel with the move component tool.
Is there anyway to set up a boundary so that the parts...
So I have some graduated markings that span a distance of 110mm and there is a dash every 5mm I sketch the first line and get "sketch fully constrained" but as soon as I pattern that linearly I get "sketch needs 440 constraints" any idea on why its not bringing my constraints along with the...
So I need to do a section of inertia on a part that has a threaded hole that runs thru the entire part.
when using the section inertia tool it has the option for solid or hollow. when you choose hollow it asks for a "hollow thickness"
what thickness is it wanting exactly? the OD of the...
So I need to do a section of inertia on a part that has a threaded hole that runs thru the entire part.
when using the section inertia tool it has the option for solid or hollow. when you choose hollow it asks for a "hollow thickness"
what thickness is it wanting exactly? the OD of the...
Hello, So im trying to add a Helix to a screw that has a MIN thread depth that runs at an angle for 11.2mm and then runs out straight for the remainder of the shank.
I have attached a snip of the drawing. The line highlighted orange, is the spline i am trying to run the helix along.
any idea on...
