Dear all!
I am practically new at using NX. I am using NX11. Currently I am dealing with a problem preparing deformable part for adding to ASSY. I know that you can't assign features such as edge blend to deformed part. I am hoping to get some advice on preparing the part to suit the final...
Dear fellow engineers!
I have designed my own (safety) clutch for some special machine. I used steel disc in the middle and on each side a ferod(some friction material) plated discs. So I was assuming it is single plated clutch. The two side discs are bolt tightened to middle disc with maedler...
Dear fellow engineers!
I have a question for you all about some (hopefully) basic theory about drives. The problem is visualized in the lower figure and will describe the circumstances. The round parts in the figure are wheels. One of them is made of steel and the other is made of rubber - both...
Dear fellow engineers!
I have a question about creating correct model for FEM structural analysis of thin plate that has one dimension significantly smaller than other two. Approx. dimensions of plate (X)800 x (Y)600 x (Z)(+-30) mm and thickness is 0.8 mm. Plate has cuts/holes on it on multiple...
Dear fellow engineers!
I have a simple question about operating principle of flat belt and pulley that has inclined pulley. Visualization on the picture. The smaller(lower) pulley is driving pulley and the bigger one is driven. The axis of the bigger pulley gets inclined for few degrees because...
