Hello all,
I'm trying to model a welding problem between Cu-Al-Cu stack-up. Al melts before Cu and when that happens, I want to introduce cohesive contact behavior into the model. The model uses friction-less hard contact behavior until then.
I import material state without updating the...
I have a 3 layer stack-up which are all in contact at the beginning of the simulation. At the end of the simulation, they separate due to applied pressure. Now, if I were to restart this simulation with the same applied pressure, some parts of the stack-up are no longer in contact. How do I make...
I'm trying to transfer voltages between two coupled thermal-electric analyses. Any suggestions?
I tried going the pre-defined field route but I can only import 'epot' as a field variable to modify material properties using USDFLD. So, not helpful.
I also can't use DISP to import voltages since...
I'm trying to model a Resistance Spot Welding process using an implicit and transient thermal-electric problem on ABAQUS and came across this problem. Here's a simple test case in which i replicated the problem.
Consider the following axisymmetric analysis (no heat flows in or out of the...
